The DFI-6000 Series expansion joint provides the ultimate in design when ease of installation and belt removal and/or replacement are factors of importance.

This high temperature joint provides the easiest installation procedures available.

With the formed flanges being factory punched the installation crew has only to align these holes with those of the companion flanges and bolt up. With both the bolt and nut being readily accessible, final tightening could not be quicker nor easier.

The belt is retained by bolts and nuts which are set up and away from the other system components, which may limit wrench maneuverability. The liner, which is welded to the formed flange, can be easily fitted with a fly ash shield.

Installation of our INSULATION SOCK, should it be required, can be done at the factory without any changes from the basic design shown here.

The DFI-6000 series joint provides functional quality while eliminating installation and design problems that have been previously encountered within the expansion joint industry.

Flow liner design must be based on specific data for each application in order to maximize the effectiveness and provide an extended service life of the joint. Your sales representative can discuss several variations to best handle the media within your system.

THE FOLLOWING DATA IS MEANT AS A GUIDE ONLY.